Keep a hydrostatic rotary table accurate for life with a simple routine: pre-run 10–15 min to build the film, maintain NAS 5 oil, service the filter ~500 h, and monitor pressure and film thickness.
После пуска дайте столу 10–15 мин на работу, чтобы плёнка установилась полностью.
Точность ±0,001 мм и бесконечный ресурс сохраняются.
Sau khởi động, chạy bàn 10–15 phút để màng ổn định hoàn toàn.
Giữ ±0,001 mm và tuổi thọ vô hạn của màng.
Après le démarrage, laisser tourner la table 10–15 min pour stabiliser le film.
±0,001 mm et vie infinie conservés.
Nach dem Start 10–15 min laufen lassen, bis der Film vollständig steht.
±0,001 mm und unendliche Lebensdauer bleiben erhalten.
After startup or long shutdown, run the table for 10–15 minutes before heavy cutting. This lets the pump, filtration, and temperature loop establish a complete, stable oil film so the worktable floats fully non-contact.
Following this keeps rotary positioning at ±0.001 mm and preserves the theoretically infinite life of the non-contact film.
